ELDI · Ignition
Feeler gauge 0.40 mm
Single blade for contact breaker gap and air gap on ignition and lighting coils
- Article
- EAN
- 4057233171171
- Weight
- 0.01 kg
- Category
- Ignition tools
- Brand
- ELDI, Ellinghaus & Dickmann
Price and availability in the shop. Article MG00088190.
ELDI · MG00088190 · WUPPERTAL
What the tool does
A single feeler gauge blade made from steel, 0.40 mm thick with a red handle. Not a set, but exactly the one measurement constantly needed on classic moped ignitions.
When you need it
For setting the air gap of the ignition coil and lighting coil to the flywheel, and for checking the contact breaker gap where the manufacturer specifies 0.40 mm.
How to use it
Turn the flywheel until the pole shoes sit exactly in front of the coil core.
Slide the blade between the flywheel and the coil core. It must go through with slight resistance.
Loosen the coil, press it against the blade, tighten it, pull the blade out.
Check at several points around the circumference; unequal values indicate a poorly centred base plate.
Without a defined measurement, the coil sits either too far away (weak spark, dim lights) or too close (flywheel rubs, coil gets destroyed).
Wipe the blade with a dry cloth before use. Oil on the blade falsifies the feel when pulling it through.
Fits
- Hercules, Zündapp, Kreidler, Miele, DKW and KTM mopeds
Vehicle data according to the manufacturer data in the shop. If in doubt, measure thread and dimensions on the vehicle.
eldi.de/en/tools/zuendung/fuehlerlehre-0-40/ · Article MG00088190 · EAN 4057233171171
